GB-19GB-18
Larger food remnants
can be cleaned by
rinsing the lter under
running water.
For a more thorough
clean, use a soft
cleaning brush.
Reassemble the lters
in the reverse order
of the disassembly,
replace the lter insert,
and rotate clockwise to
the close arrow.
WARNING
• Do not over tighten the lters. Put the lters
back in sequence securely, otherwise coarse
debris could get into the system and cause a
blockage.
• Never use the dishwasher without lters in
place. Improper replacement of the lter may
reduce the performance level of the appliance
and damage dishes and utensils.
Spray arms
It is necessary to clean the spray arms regularly
for hard water chemicals will clog the spray arm
jets and bearings.
To clean the spray arms, follow the instructions
below:
To remove the upper
spray arm, hold the
nut, rotate the arm
clockwise to remove it.
To remove the lower
spray arm, pull out the
spray arm upward.
Wash the arms in soapy and warm water and use
a soft brush to clean the jets. Replace them after
rinsing them thoroughly.
To Next Page
Loading...
