GB-25GB-24
Water Supply And Drain
Cold water connection
Connect the cold water supply hose to a threaded
3/4(inch) connector and make sure that it is
fastened tightly in place.
If the water pipes are new or have not been
used for an extended period of time, let the
water run to make sure that the water is clear.
is precaution is needed to avoid the risk of
the water inlet to be blocked and damage the
appliance.
About the safety supply hose
e safety supply hose consists of the double
walls. e hose’s system guarantees its
intervention by blocking the ow of water in
case of the supply hose breaking and when the
air space between the supply hose itself and the
outer corrugated hose is full of water.
WARNING
A hose that attaches to a sink spray can
burst if it is installed on the same water line
as the dishwasher. If your sink has one, it is
recommended that the hose be disconnected and
the hole plugged.
How to connect the safety supply hose
1. Pull the safety supply hoses completely out
from storage compartment located at rear of
dishwasher.
2. Tighter the screws of the safety supply hose
to the faucet with thread 3/4inch.
3. Turn water fully on before starting the
dishwasher.
How to disconnect the safety supply hose
1. Turn o the water.
2. Unscrew the safety supply hose from the
faucet.
safety supply hose
ordinary supply hose
To Next Page
Loading...
