GB-29GB-28
adjustment of the screwing level of the feet.
In any case, the appliance should not be inclined
more than 2°.
NOTE:
Only apply to the free standing dishwasher.
Free Standing Installation
Fitting between existing cabinets
e height of the dishwasher,
845 mm, has been designed
in order to allow the machine
to be tted between existing
cabinets of the same height in
modern tted kitchens. e
feet can be adjusted so that
correct height is reached.
e laminated top of the
machine does not require
any particular care since it is
heatproof, scratchproof and
stain proof.
Underneath existing work top
(When tting beneath a work
top)
In most modern tted
kitchens there is only one
single work top under which
cabinets and electrical
appliances are tted. In this
case remove the work top of the dishwasher by
unscrewing the screws under the rear edge of the
top (a).
Attention
After removing the work top, the screws must be
screwed again under the rear edge of the top (b).
e height will then be reduced to 815 mm,
as scheduled by the International Regulations
(ISO) and the dishwasher will t perfectly under
the kitchen working top
To Next Page
Loading...
