FAR LVC515DS - Water and Drain Connections; Drain Hose Connection; Excess Water Drainage and Extension; Pre-Start Checks

ENGLISHENGLISH
GB-35GB-34
Connection of drain hoses
Insert the drain hose into a drain pipe with a minimum diameter of 4cm, or let it run
into the sink, making sure to avoid bending or crimping it. e free end of the hose
must be at a height lower than 60cm and must not be immersed into water to avoid
the backow of it.
PLEASE HANG UP THE DRAIN HOSE EITHER WAY OF A, B
NOTE
The top of the hose must be
less than 600 mm.
FRONT
Drain pipe
A
B
40mm
Counter
MAX 600mm
How to Drain Excess Water From Hoses
If the sink is 100 0 higher from the oor, the excess water in hoses cannot be drained
directly into the sink. It will be necessary to drain excess water from hoses into a
bowl or suitable container that is held outside and lower than the sink.
Water Outlet
Connect the water drain hose. e drain hose must be correctly tted to avoid water
leaks. Ensure that the water inlet hose is not kinked or squashed.
Extension Hose
If you need a drain hose extension, observe to use a similar drain hose.
It must be no longer than 4 metres; otherwise the cleaning eect of the dishwasher
could be reduced.
Start of dishwasher
e following things should be checked before starting the dishwasher.
1. e dishwasher is level and xed properly.
2. e inlet valve is open.
3. Inlet hose connections are fully tightened and not leaking.
4. e wires are tightly connected.
5. e power is switched on.
6. e inlet and drain hoses are not kinked.
7. All packing and print materials should be taken out of the dishwasher.
ATTENTION:
After installation, please make sure to keep this manual.
e content of this manual is very helpful to the users.