OPERATION
Fill the required amount of water into the carafe • (10). Pour the water into the
water tank (5) (ill.
f
). Check the water-level indicator (5a) in the inside of the
water tank (5) (ill.
g
).
Close the lid • (3) (ill.
h
).
Place the carafe • (10) on the keep warm plate (9) (ill.
h
).
NOTE: Ensure the appliance is assembled correctly and completely.
NOTE: It is possible to place a paper lter into the lter housing (14) instead of the
permanent lter (15). Only use a lter of the cone type 1x2 (for 4-6 cups).
NOTE: Do not place a paper lter in the permanent lter (15), as water will not ow
freely through the permanent lter (15).
Connect the plug• (6) to a wall outlet (ill.
i
).
The appliance is now is stand-by mode. On the display • (19), “12:00” will ash
for about 5 seconds and then change to be displayed constantly. The display
backlight will be fully illuminated for about 30 seconds before dimming.
NOTE: Pressing any button at any stage will cause the display backlight to switch to
full illumination for about 30 seconds before returning to being dimmed.
Setting the clock
NOTE: Setting the clock is required to be able to use the AUTO function.
NOTE: The appliance has a 12-hour display (-/PM).
Press and hold• HOUR (20) or MIN (18) button for about 1 second to enter the
clock setting mode.
Press the • HOUR button (20) to set the hours on the clock. Each press will advance
the clock by one hour.
Press the • MIN button (18) to set the minutes on the clock. Each press will
advance the clock by one minute.
NOTE: Press and hold either the HOUR (20) or MIN (18) button, to advance through
hours/minutes rapidly.
NOTE: The clock will be reset if the appliance is unplugged from the wall outlet and
not reconnected within 15 seconds. The clock needs to be set again.
NOTE: If no button is pressed for about 5 seconds, the set time will be saved and
the appliance returns to stand-by mode.
5-cup Coffee Maker_103743_IM_US_V2_121212.indd 9 12/12/12 3:53:20 PM
To Next Page
Loading...
