3.5 Shift Light Settings (tell-tale at 4 and 5)
The next two settings are for the shift lights. Use the push button to set the rpm at which you
would like the first and second shift lights to illuminate. Remember to hold the push button
pressed for 5 seconds after each adjustment to move on to the next. After the last shift light is
set, the tacho will initialise as if it had been switched on.
3.6 Resetting the Tell-Tale
In auto reset mode, the maximum rpm recorded is shown after switch on and the hands have
been driven into the stops. To reset this value, or the tell-tale hand when in manual mode, simply
press the push button after the tell-tale reading has been shown.
Important Notes
Further steps in the set up process can be skipped at any time by switching off the tacho
but only the settings that have been terminated with the 5 second long push button press
will be saved.
If you increase a setting so that it reaches the maximum on the scale, it will “wrap” round
to 1 if the setting is increased again. This allows you to set up a 16 cylinder engine on a 0
to 8000 rpm dial. When this wrap occurs, the tell-tale hand steps on half a division to
indicate that this has happened.
****** To set the tacho back to the factory settings (4 cylinders, mode 4, filter 4, shift
lights 7000 and 8000 rpm), enter set up mode and press button for 20 seconds. ******
To Next Page
Loading...
Need help?
General