Fast Bazooka BT6014 User Manual

How to install the FAST-9999 with the FAST-BTAH
The FAST-9999 universal harness uses the patented Posi-Tap connector from Posi-Products for making
FAST secure connections to your OEM wire harness.
Posi-Tap TM Patent # 5,228,875 5,695369 5,868,589 6,692,313 Jap 2881414, Aus 708700, Tia 103534, Can 2204826
Mex 200626 Korea 477279, China Z197105562.9 & others pending
Disconnect negative battery clamp from battery.
For easiest installation remove the radio and disconnect
the harness from the back of the radio.
Connect the Posi-Tap connectors to the corresponding
wires of your radio harness. Consult your car or radio
manufacturer’s manual to get the correct color codes
for your vehicle.
Red
(+) 12V Power. Turns on when ignition/accessory is on.
Blue/White Turns on remote accessories (amplifiers, etc.).
If there is no Remote Amplifier wire, you can often use the
power antenna wire.
White (+) Left Front Speaker
White/Black (-) Left Front Speaker
Gray (+) Right Front Speaker
Gray/Black (-) Right Front Speaker
Remove the top cap. Place the wire
that is going to be tapped. In the
grove of the cap as far down as it
will go.
Make sure not to cross thread the
cap when screwing it back in place.
Make sure the end with the 6 pin Molex connectors is
toward the radio. Run the BTAH harness behind radio,
dash and along the edge of the vehicle until you get
to the place you have decided to mount the tube.
Continue to thread until the cap
is tight and the wire is pierced.
Make sure to attach all 6 of the
FAST-9999 harness wires to
your OEM harness.
Plug the FAST-9999 harness into
the FAST-BTAH. Mount grounding
ring and plug the 14 pin connector
into the BASS TUBE. For more information
on placement and mounting, consult
your amplified tube instruction manual.
FAST-9999
14 pin connector
to the BAZOOKA
Ground to
chassis of
vehicle
FAST-BTAH

Fast Bazooka BT6014 Specifications

General

Brand	Fast
Model	Bazooka BT6014
Category	Subwoofer
Language	English

Summary

FAST-9999 and FAST-BTAH Installation

Wire Identification and Connection

Identify and connect FAST-9999 harness wires to corresponding OEM wires based on color codes.

Posi-Tap Connector Usage

Instructions on how to use the Posi-Tap connectors to secure wire connections.

Mounting the Bazooka

Wiring Diagrams

A100 Wiring

A200 Wiring

Product Specifications

Amplified Tube Specifications

Detailed specifications for various amplified Bazooka subwoofer models.

Passive Tube Specifications

Detailed specifications for various passive Bazooka subwoofer models.

Marine Tube Specifications

Marine Model Specs

Detailed specifications for marine Bazooka subwoofer models.

Input Signal Connections

High-Level Input Wiring

Power and Ground Connections

Power Wire Installation

Proper procedure for connecting the power wire directly to the battery positive terminal with a fuse.

Ground Wire Installation

Proper procedure for connecting the ground wire directly to the vehicle chassis.

Remote Turn On Options

Amplifier Adjustments and Indicators

Crossover Adjustment (A200)

How to set the variable crossover point for A200 models to optimize bass response.

Level Setting (A200)

Passive Model Connections

Single Voice Coil Wiring

Dual Voice Coil Wiring

Troubleshooting

Phase Diagnosis

Procedure to diagnose and correct phase issues by checking bass output with balance control.

Phase Correction

Step-by-step method to identify and correct phase issues between multiple Bazooka units.