41 Specify X minutes for which stage 1 will function until
stage 2 is activated to help raise (or cool) temperature
(if the temperature set point is not reached). This
function avoids excess compressor wear in the case
where the necessary temperature set point is not met
(see 37, 38 & 39). Set to “00” to disable.
41
42 HP “ON” when Furnace On: Heat Pump and
Furnace can operate together when 2nd stage
furnace is required.
HP “OFF” when Furnace On: turns off the Heat Pump
when the furnace is On (required on some gas or oil
furnaces).
42
ADVANCED SETTINGS PAGE 4 ADVANCED SETTINGS PAGE 5
To Next Page
Loading...