a)
b)
7.1.1
7.1.2
Before you begin, ensure that
• Τhere is glue in the applicator reservoir (Fastbind Hot-Melt)
• Machine has warmed up at least 20 min
• Τhat softcover nipping plate is attached (marked with “S”)
• Τhe turntable is in normal position.
• Τhe paper guide is in place (S or H-model)
PREPARATIONS:
a. Fold one A4 or letter size paper sharply along the long side so that
the folding line divides the paper in approximately ratio 30_:_70%
Open the clamp and place the folded paper on positioning
deck. Align the paper against paperguide.
Take a strip and make a sharp folding line on one side of the
strip.
a)
a) Folded strip.
b) Place the folded strip on paper. Note strip’s alignment:
short folded part against the turntable while the long
tail comes towards and on top of the nipping tool.
7.1. LOADING STRIP AND PAPERS
Section 7
BINDING WITH STRIP
Check List & Preparations
Binding Procedure
BINDING WITH STRIP
1 - 16
To Next Page
Loading...
