f. Connecting the power cord
• Once you have checked that local power supply matches with
the machine’s operating voltage, connect the mains lead.
• Press the main switch to turn the machine on. The green power
indicator light should light up green.
g. Let the machine warm up for 20 minutes. During this time glue in the
applicator’s reservoir melts, and the applicator will run easily along the
guide rail. Now the machine is ready to use.
Note that even the best hot melts degrade during the time in high
temperatures. To preserve adhesive’s chemical properties and minimize
energy consumption, turn the machine off when not working with it.
Alternatively one can use external timer to switch off the electricity after pre-
set time limit. Timer is available as an optional accessory.
SETUP
1 - 8
To Next Page
Loading...
