“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-200 Starogard Gdański tel/fax:+48 58 56 300 80 www.ega.com.pl
Translation of the Original Instruction
Manual
WARNING! BEFORE ACCESS TO USE THE EQUIPMENT, PLEASE READ THIS
MANUAL CAREFULLY AND SAVE IT FOR FURTHER USE
Technical data
This appliance is designed for soldering only on 190 g gas cartridges. Ideal burner
for soft and hard soldering, for repair, installation, DIY, paint tanning, weed removal,
flame cleaning, tin plating, plastics processing, tanning, defrosting, loosening
Screws, bending and shaping of pipes, PVC tubes, as well as for firing a barbecue
or a bonfire.
Gas soldering iron lamp for cartridges
- gas consumption 182 g / h
- flame temperature: 1350 ° C
- power: 2,5 kW
- piezoelectric ignition
- dedicated gas cylinders: Disposable butane propane butane 190 g
(EN417-TYPE200) with anti-leakage protection.
BY CURRENT MODIFIED REGULATION WITH EN417: 2012 FROM 1 APRIL 2014 ALL
GAS CARDS IN THE EUROPEAN UNION SHOULD BE EQUIPPED WITH THE ILL
SYSTEM (INTERNAL GAS LEVEL).
Workplace
1. The workplace should be clean and well lit. The mess on the workbench and
insufficient lighting are conducive to accidents.
2. Do not operate the device in an explosive atmosphere, such as near flammable
liquids or gases or dust.
3. No person or children may be near anyone working with the burner. Distraction
may result in loss of control of the device.
Specific safety regulations
Before connecting the gas container, make sure there is a seal between
Device and container and whether it is in good condition.
- Do not use the device with damaged or worn gaskets.
- Do not use a device that is leaking, damaged, or working in the wrong way.
- Only use the device in a well ventilated device.
To Next Page
Loading...