EasyManua.ls Logo

FASTER TOOLS 4621 - Operation, Maintenance, and Disposal; Operating the Blow Torch; Replacing the Gas Container; General Maintenance and Gasket Check

FASTER TOOLS 4621
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
“EGA Spółka z o.o.” Spółka Komandytowa ul. Rzeczna 1, Nowa Wieś Rzeczna
83-200 Starogard Gdański tel/fax:+48 58 56 300 80 www.ega.com.pl
USE
To light up the device, proceed as follows.
- Open the gas flow control valve approximately 1/4 turn counter clockwise and
immediately ignite the device at the burner with a piezo lighters.
- By turning the regulating valve towards (+) plus or (-) minus (counter clockwise or
clockwise), set the power of the device to achieve full / saturated flame.
- If the appliance is cold or is used with a new disposable container, the produced
flame may be irregular or the gas may escape in the liquid phase. This is normal
and does not mean defects. The flame will stabilize after 2-3 minutes or after the
appliance has heated up. During this time, the device should be held vertically.
REPLACE GAS BOX
To replace the gas bottle, proceed as follows.
- Before unscrewing the used disposable container, make sure the flame is off, the
flow control valve is closed, the appliance has cooled completely, and the
container is empty. Shake the device to determine if there is still liquid in the
container.
- Keep the gas container out of the reach and away from others.
- Carefully unscrew, counter clockwise, and handle the disposable container from
the appliance.
- Check the gasket before attaching the new gas container.
- Disconnect the disposable container into the appliance as described previously.
GASKET
Make sure the rubber seal is intact and in perfect condition.
GENERAL MAINTENANCE
- No maintenance required.
- The nozzle does not require cleaning.
- Do not make any changes to your device.
- In the event of a malfunction, please return the unit to the store for replacement.
RECYCLING
Non-recyclable equipment should be recycled at a collection point for recyclable
materials. Do not dispose of in municipal waste containers. Packaging must be
disposed of in accordance with the type of material and the local regulations in
force in your area.