Problem Possible cause/Solution
Spinning starts late or the ma-
chine does not spin:
The electronic unbalance detection device has cut in because the laundry
is not evenly distributed in the drum. The laundry is redistributed by reverse
rotation of the drum. This may happen several times before the unbalance
disappears and normal spinning can resume. If, after 10 minutes, the
laundry is still not evenly distributed in the drum, the machine will not spin.
In this case, redistribute the load manually and select the spin programme.
• Redistribute the laundry.
The load is too small.
• Add more items, redistribute the load manually and then select the
spinning programme.
If you are unable to identify or solve the problem, con-
tact our service centre. Before telephoning, make a
note of the model, serial number and purchase date of
your machine: the Service Centre will require this in-
formation.
Mod. ... ... ...
Prod. No. ... ... ...
Ser. No. ... ... ...
Mod
.
..
. ...
.
.
.
Pro
d. N
o
.
... ... ..
S
e
r. No
.
... ... ...
Technical data
Dimensions Width
Height
Depth
60 cm
85 cm
63 cm
Electrical connection Information on the electrical connection is given on the rating plate, on
the inner edge of the appliance door.
Water supply pressure Minimum
Maximum
0,05 MPa
0,8 MPa
Maximum Load Cotton 6 kg
Spin Speed Maximum 1200 rpm (FWG 3125)
1400 rpm (FWG 5145)
Consumption values
Programme Energy consumption
(KWh)
Water consumption (li-
tres)
Programme duration
(Minutes)
White Cottons 90° 2.0 61 135
Cottons 60° 1.3 58 125
Cotton ECO 60°
1)
1.14 54 155
Cottons 40° 0.7 58 120
15
To Next Page
Loading...