5
Recommended Servo List (JR)
• Canard: (1) 8611a
• Elevons: (2)
• Rudder: (1) 3421
• Nose Steering: (1) 2721
• Retracts: (1) 351 or equivalent
• Brakes: (1) 351 or equivalent
Recommended Servo List (Hi-Tec)
• Canard: (1) HS-645MG or HS-5645MG
• Elevons: (2) HS-5955TG (new Number is HS-7955TG)
• Rudder: (1) HS-245MG or HS-5245MG
• Nose Steering: (1) HS-645MG or HS-5645MG
• Retract Valve: (1) HS-225 or equivalent
• Gear Doors (2) HS-225 or equivalent
• Brakes: (1) HS-225 or equivalent
Other Parts
• Bifurcated Pipe
• Pull-Pull Steering Cable
• BVM UAT or equivalent (optional / but highly recommend)
• ½ inch Velcro straps to secure fuel tanks, receiver, air tanks, ECU
• Wire twist tie (optional)
• Blue Loctite
• Glues: Loctite Hysol 9462, Thin CA, 15 minute epoxy
• Electronic gear sequencer(RCBEE from RC Jet Models or equivalent)
• Brake valve or Electronic Actuator
• Batteries, regulator and switch
• Servo extensions (length may vary, depending on receiver placement)
• Ordinance Package
Construction
The order of construction may be changed to suit your personal preference
Note: any fiberglass surface on the inside of the airframe that requires components to be
bonded should be cleaned with solvent to make sure that any mold release agent is removed
and should be scuffed with medium grit sandpaper to promote adhesion prior to gluing.
Step 1: Wings – Hinging of Elevons and Servo Installation
Note: First production kits were supplied with only three hinge points in each Elevon section,
this was found to be insufficient for this large of surface, it is imperative that if you have a
version that is only supplied with three hinges you must add two more hinge points as shown in
Photo 1.
To Next Page
Loading...
