Need help?Do you have a question about the Fbt HiMaxX100Sa and is the answer not in the manual?
Details the 8 M10 anchoring points for suspended installation and support verification.
Explains the function, poles, and characteristics of XLR, SPEAKON, RCA, and JACK connectors.
Illustrates two methods for connecting the sub to satellites using FILTERED OUT or LINK.
Explains the function of the THERMAL and LIMITER LEDs on the rear panel.
Describes the PHASE switch for alignment and VOL for general level control.
Details IN link OUT for signal transfer and GND LIFT for noise reduction.
Explains the power indicator, main power socket, and fuse housing.
Details the 8 M10 anchoring points for suspended installation and support verification.
Explains the function, poles, and characteristics of XLR, SPEAKON, RCA, and JACK connectors.
Illustrates two methods for connecting the sub to satellites using FILTERED OUT or LINK.
Explains the function of the THERMAL and LIMITER LEDs on the rear panel.
Describes the PHASE switch for alignment and VOL for general level control.
Details IN link OUT for signal transfer and GND LIFT for noise reduction.
Explains the power indicator, main power socket, and fuse housing.
General| Type | Active Subwoofer |
|---|---|
| Driver Size | 18" |
| Input Type | Balanced |
| Input Connectors | XLR |
| Enclosure Material | Plywood |
| Enclosure Type | Bass Reflex |
| Connectors | XLR |
| Configuration | Bass Reflex |
| Input Impedance | 22 kOhm |
To Next Page
