EasyManua.ls Logo

FD smart - SAFETY AND MAINTENANCE ADVICE; Usage and Battery Safety Precautions; Simple Maintenance and Troubleshooting

Default Icon
18 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
1.When use remote control function, the distance from adult to the car
can not exceed 10 meters.
2.Only the guardian can use the remote controller, not allow children
to touch or use it.
3.Please read the instructions before use remote control, and take empty
testing. After operate the car skillful, then allow child to ride it.
4.Don’t ride this product on roadway and water place.
5.To avoid circuit damaged, remote control can not get wet in the rain
or be immersed in water by other ways.
6.Suggest to take out battery if do not use controller for long time, otherwise
battery may be leak and corrode circuit board, to damage the controller.
7.Controller must prevent falling in using.
8.Please keep the controller carefully, prevent missing.
9.If the control range under 3 meters, it means the battery is low power,
please replace 2 AA batteries. Replace battery: Screwing out the
screw by screwdriver, push out the cover according to arrow pointed,
and place 2 AA batteries in right polarity, and then fit on cover.
Safety Warning of Usage
•Charger, accumulator and dry battery are not toys, prohibit children to
play.
•Non-rechargeable battery can not be charged, if you use non rechargeable
battery, please do not charge.
•Different type of battery [alkaline /standard(carbon-zinc)/rechargeable
battery(Ni-Ca)]or new and old or different brand of battery can not mix
used.
•Rechargeable battery must be charged by guardian.
•Battery must be placed in right polarity.
•Please take out use up battery from the toy.
•Please take out battery if do not use for long time.
•Power terminals can not short circuit.
Safety Warning of Battery
1.Remote controller does not work. (No reaction)
A.Check whether the remote receiver place in suitable position.(away
from motor)
B.Check whether the power of remote control transmitter is on (Red
light of the transmitter in on)
2.On and off, bad contact conditions while operate the remote controller.
A.Check whether the capacity on motor break off ,tack weld.
B.Whether strong hertzian waves and radio interference near by, such as
high voltage cable,large machine,motor, radar and etc.
Simply maintain
13