FD smart - ASSEMBLE STEPS; Assemble Wheels; Assemble Other Parts

To Next Page

To Previous Page

ASSEMBLE STEPS

Assembling of car must be operated by adult.

Choking hazard-small parts.not allow children to touch and play!

Please check the quantity of all parts before assembling.

Please keep the PP bag carefully.choking hazard,prohibit children to play it!

Tools of assembling: screwdriver,scissors(not included)

1 .Assemble wheels:

①Place the car upside down on a flat surface.

②Assemble rear wheels:

Double-motor version: Insert the rear wheel into the rear shaft by pushing

the wheel center, then snap wheel cover in place. Repeat for opposite side.

Single-motor version:

Insert the washer, wheel and wheel cover in place for the left side. Insert the

wheel and wheel cover in place for the right side.

③Assemble front wheels: Insert the washer, front wheel (pushing the wheel

center to the shaft) and wheel cover in place. Repeat for opposite side.

wheel cover

Front wheel Front wheel

Washer Washer

Washer

Right

Left

Back

Front

Note:Only for single-motor version.

①Complete rear wing assembly first,

then insert the rear wing unit into car

body and press down until it 'snap'

securely.

②Put the seat into car body, and install

seat screws 4x12mm 8mm securely.

2.Assemble other parts:

Installation of rear wing

Screw

4×12mm 8mm

Screw

4×12mm 8mm