Feasa 10-F User Manual

FEASA LED ANALYSER
FUNCTIONAL VERSION
Command Summary:
COMMAND DESCRIPTION
s etLOG Set the Intensity Response to Logarithmic Mode
set LIN Set the Intensity Response to Linear Mode
setBAUD Set the baud rate of the Serial Port
getBAUD Get the Baud Rate the Analyser is set to
set R ange@@# Set the capture range of the Analyser for the capturemulti command
getRange@@ Get the capture range of the Analyser for the capturemulti command
setFACTOR## Set the Sensitivity Level (Exposure Factor) of the Led Analyser
getFACTOR Get the Exposure Factor
set photopic # Set photopic mode OFF for the Led Analyser
getphotopic Verify what photopic mode is set
setautopwm Change Auto Capture mode to an Auto PWM Capture mode
getautopwm Verify if the Analyser is in Auto capture or Autopwm capture mode
setabsintmulti@@m.mmmmme+mm Set the Absolute Intensity Correction Factor of the Led under test.
getabsintmulti@@m.mmmmme+mm Get the Absolute Intensity Correction Factor of the Led under test.
s etINTGAIN Set the Intensity Gain of the Led Analyser
getINTGAIN## Get the Intensity Gain Factor
s etXOFFSET Set the X Offset of the Led Analyser
getXOFFSET## Get the x Chromacicity Offset
SetYOFFSET Set the Y Offset of the Led Analyser
getYOFFSET## Get the y Chomacicity Offset
s etWavelengthOFFSET## Set the Wavelength Offset of the Led Analyser
getWAVELENGTHOFFSET@@ Get the wavelength offset for fiber
setcalibration # # Set the Calibration version of the USER
s etCalibrationDateddmmyyyy Set the Calibration Date of the USER
getcalibrationdate Get the Calibration Date set by the user
Back to Index
123

Feasa 10-F Specifications

General

Brand	Feasa
Model	10-F
Category	Measuring Instruments
Language	English