1
Sienna Bed
Assembly Instructions
Pre-assembly Preparation
Please read these instructions fully prior to assembly to familiarise yourself with the various stages of
construction. Carefully open all packs supplied and check the contents against the parts and fittings check
list.
Do not destroy any of the packaging until you are certain that you have all the necessary parts for the
assembly.
This item is heavy once assembled. Please try to assemble the item as close as possible to the point of use.
Take care when moving the item to avoid personal injury or damage to the product and always lift rather
than drag.
There are small components used in the construction of this bed as well as plastic foil packaging,
these should be kept away from young children whilst assembling your bed.
This product requires a minimum of 2 people to assemble.
Product Safety
All assembly fastenings should always be tightened properly and care should be taken to ensure that no
fittings are loose.
Periodically check and ensure that all components are in their proper position, free from damage, and that
all connectors are tight.
Once the bed is assembled, do not sit, stand or apply weight directly to the slats unless the mattress is in
place.
Product Care
The fabric is dry clean clean and spot clean only.
Do not use abrasives or cleaning products which may contain ammonia or solvents
If you require any advice during assembly please call our customer service team on 01243 380600.
To Next Page
Need help?
General
