Noah Changing Table
IMPORTANT READ CAREFULLY – RETAIN FOR FUTURE REFERENCE
• Please take a few quite minutes to read these instructions
• Lay out the parts on a clean, flat surface and compare with the parts checklist. Save all packaging until
assembly is complete to avoid accidentally discarding fittings
• All assembly fastenings should always be tightened properly and care should be taken that no fittings
are loose
• Before each usage or assembly, inspect changing table for damaged hardware, loose joints, missing
parts or sharp edges. Do not use changing table if any parts are missing or broken
• To properly protect wood, avoid direct sunlight and excessive temperatures
• To clean, slightly moisten cloth with water and wipe surfaces. A damp cloth holds dust and prevents
damage. Repeat with a dry, soft, lint-free cloth
• Do not use abrasives or cleaning products which may contain ammonia or solvents
TOOLS REQUIRED:
• Please use Philips Head Screwdriver (not included) and Allen key part G (included) to assemble the
Changing table.
WARNING: To prevent injury always keep child within arms reach. Never leave child
unattended.
To Next Page
Need help?
General
