EasyManua.ls Logo

Feature tech AW07A - User Manual

Feature tech AW07A
7 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
AW07A Instruction Manual
AW07A HF/VHF/UHF Antenna Analyzer
INTRODUCTION
AW07A antenna analyzer is a compact battery powered RF impedance analyzer. It can test the SWR
status of your antenna, measure the impedance and reactance component and help you to solve antenna
problems. This unit combines six basic parts: a variable oscillator, frequency counter, independent oscillator,
50 ohm RF bridge detector, an A-D converter, and microcontroller. This compact product was built to feed the
need for the solid construction and field test. The operating frequency range of this unit goes from HF, and
extends up to 490MHz. It is specially designed for analyzing 50ohm antenna system. It measures RF
impedances from a few ohms to several hundred ohms. The AW07A is also an L/C meter, measuring the
values of capacitors and inductors. Additionally, it could be a non-precision signal source and frequency
counter. With a built-in RF strength meter, it tests the RF field strength near your antenna system, and it’s
very useful when you need to know the RF interference status around your station. The AW07A also
functions as a non-precision signal source and frequency counter. The operating frequency range of this unit
extends from 1.5 to 71 MHz in six overlapping bands, and includes SWR measurements on 85-185MHz ,
300-490 MHz.
1
Question and Answer IconNeed help?

Do you have a question about the Feature tech AW07A and is the answer not in the manual?

Feature tech AW07A Specifications

General IconGeneral
BrandFeature tech
ModelAW07A
CategoryMeasuring Instruments
LanguageEnglish

Summary

INTRODUCTION

GENERAL GUIDE

Backlight Control

Instructions on how to adjust the backlight using the "Up" button.

Automatic Menu Entry

Describes the default menu navigation and how to select modes.

BAND SELECTING

Switch to UHF Mode

Steps to configure the analyzer for UHF band operation.

Switch to VHF Mode

Steps to configure the analyzer for VHF band operation.

Switch to HF Mode

Steps to configure the analyzer for HF band operation.

Antenna Mode

Frequency Counter Mode

SIGNAL GENERATOR

EXTERNAL POWER SUPPLY

INTERNAL BATTERIES GUIDE

ANTENNA ADJUSTMENT HINTS

Dipole Antenna Adjustment

Guidance on adjusting dipole antennas, including baluns and feedline effects.

Vertical Antenna Adjustment

Guidance on adjusting vertical antennas, focusing on radial systems and tuning.