To Next PageTo Next PageWhy air from Fedders A6V05S2B does not feel cold enough?
If the air from your Fedders Air Conditioner doesn't feel cold enough, there are a few things to check. First, make sure the unit isn't in Fan mode; set it to Cool. Also, ensure the temperature isn't set too high; lower the thermostat. Keep in mind that cooling may not occur until the room temperature rises above 70°F.
What to do if my Fedders Air Conditioner will not operate?
If your Fedders Air Conditioner isn't operating, there are a few potential causes. First, ensure the wall plug is firmly pushed into the outlet. If that's not the issue, check your house fuse or circuit breaker, replacing the fuse with a time delay type or resetting the breaker if needed. Also, avoid turning the unit off and on too quickly; wait 3 minutes before restarting. Finally, make sure the thermostat isn't set too low for cooling; adjust it to a lower temperature if necessary.
Why is my Fedders A6V05S2B cooling but the room is too warm and ice is forming?
If your Fedders Air Conditioner is cooling, but the room is too warm and ice is forming on the cooling coil behind the decorative front, it could be due to a couple of reasons. One possibility is that the outdoor temperature is below 70°F. To defrost the coil, set the mode to Fan and adjust the thermostat to a warmer temperature. Another cause might be a dirty air filter restricting airflow. In this case, clean the filter.
What to do if Fedders Air Conditioner is cooling, but room is too warm and no ice is forming?
If your Fedders Air Conditioner is cooling, but the room is too warm and NO ice is forming on the cooling coil, it's possible that the air filter is dirty, restricting airflow. Clean the air filter. Alternatively, the thermostat might be set too warm. Try setting it to a colder temperature.
How to reduce noise from Fedders Air Conditioner when cooling?
Some noise is normal. The sound of rushing air is normal; if it's too loud, set the Fan Speed to Low. The sound of the fan hitting water in the moisture removal system is also normal when humidity is high; close doors, windows, and registers. If you notice window vibration, this could be due to poor installation; refer to the installation instructions or check with the installer.
What to do if Fedders Air Conditioner is dripping water inside?
If water is dripping inside your Fedders Air Conditioner when it's cooling, this could be due to improper installation. The air conditioner should be tilted slightly to the outside to allow for water drainage. Refer to the installation instructions or check with the installer.
General| Type | Window Air Conditioner |
|---|---|
| BTU | 5000 |
| Energy Efficiency Ratio (EER) | 10.7 |
| Power Supply | 115V/60Hz |
| Cooling Capacity | 5000 BTU/h |
| Operating Temperature | 64 - 90 °F |
Details on the arc detection device, its function, testing, and resetting procedures.
Covers electrical hazards, proper grounding, wire gauge, and general safety advice.
Step-by-step guide for installing the unit in a sliding window.
Specifies window dimensions and lists required installation parts.
Lists the tools required for installation.
Continues the step-by-step guide for sliding window installation.
Important cautions regarding air intake, bottom pan, and sealing.
Instructions for installing the unit in casement windows.
Procedure for cleaning the air filter for optimal performance.
Explains the components and functions of the electronic control panel.
Details on setting the timer, modes (Cool, Fan), and fan speeds.
Functionality of Air Exchanger, auto-restart, remote use, and battery precautions.
A guide to diagnose and solve common air conditioner operational issues.
Specific advice for dealing with poor or no cooling, including icing.
Procedures for getting service or replacement parts under warranty.
Details the warranty coverage, limitations, and exclusions.
