Why is my Fedders A6U10W2A Air Conditioner not cold enough?
If your Fedders air conditioner is not blowing cold air, check that the selector is set to the cool position and not the fan position. Ensure the thermostat is set to a colder temperature. Also, cooling may not occur until the room temperature rises above 70°F.
How to fix a Fedders A6U10W2A Air Conditioner that will not turn on?
If your Fedders air conditioner won't turn on, make sure it's properly plugged into the wall outlet. Check your house fuse or circuit breaker and replace the fuse or reset the breaker if necessary. Ensure the power control is in the ON position. If you've recently turned the unit off and on, wait approximately 3 minutes before restarting. Also, verify that the thermostat isn't set too low for cooling; adjust it to a higher setting.
What to do if my Fedders A6U10W2A is cooling, but the room is too warm and there is no ice forming?
If your Fedders air conditioner is cooling, but the room is too warm and no ice is forming on the cooling coil, ensure the air filter is clean. A dirty filter restricts airflow. Also, make sure the thermostat is set to a colder setting and the fan speed selector is set to HIGH for maximum cooling.
What to do if my Fedders A6U10W2A Air Conditioner is cooling, but the room is too warm and ice is forming?
If your Fedders air conditioner is cooling, but the room is too warm and ice is forming on the cooling coil, set the selector to the FAN position to defrost the coil, especially if the outdoor temperature is below 70°F. Clean the air filter, as a dirty filter restricts air flow. You can find instructions on how to do this in the 'Cleaning the Air Filter' section. If it's nighttime, also set the thermostat to a warmer position.
Why is my Fedders A6U10W2A Air Conditioner so noisy when cooling?
Some noise is normal. The sound of rushing air is typical. If the sound of the fan hitting the water-moisture removal system is too loud, turn the selector to a lower fan setting. If the window is vibrating, refer to the installation instructions or check with the installer to ensure proper installation.
Why is my Fedders A6U10W2A Air Conditioner dripping water outside when cooling?
If water is dripping outside your Fedders air conditioner when it's cooling, it is likely removing a large quantity of moisture from a humid room, which is normal during excessively humid days.
What to do if my Fedders A6U10W2A is dripping water inside when cooling?
Tilt your Fedders air conditioner slightly to the outside to allow for proper water drainage. This will resolve water dripping inside when the unit is cooling due to improper installation.
Covers arc detection, grounding, shock hazards, and general safety.
Details air filter cleaning and a guide for resolving common issues.
General| Cooling Capacity | 10, 000 BTU |
|---|---|
| Voltage | 115V |
| Room Coverage | 450 sq. ft. |
| Installation Type | Window |
| Fan Speeds | 3 |
| Filter Type | Washable |
To Next Page