Need help?Do you have a question about the Federal Signal Corporation SmartSiren Platinum SSP2000B and is the answer not in the manual?
General| Category | Security Sensors |
|---|---|
| Model | SSP2000B |
| Manufacturer | Federal Signal Corporation |
| Power Supply | 12 VDC |
| Standby Current | 50 mA |
| Operating Current | 2.5 A |
| Output Power | 100W |
| Humidity | 0-95% non-condensing |
| Type | Siren |
| Input Voltage | 12 VDC |
| Operating Temperature | -30°C to +60°C |
| Siren Tones | Wail, Yelp, Priority, Air Horn, Manual |
| Voltage Range | 11-16 VDC |
Safety precautions for installing siren/light systems, including qualifications and sound hazards.
Safety advice for operating siren/light systems, including visibility and sound hazards.
Details on siren tones, public address, and speaker compatibility.
Information on compatible lightbars and SignalMaster integration.
Specifications for solid-state relays in SSP3000B and SSP2000B models.
Describes four relay input circuits and their active-low/high configurations.
Explains LED indicators on the amplifier/relay module and control head.
Lists electrical and dimensional specifications for the system.
Details siren tone cycles, output, audio response, and power.
Specifies fuse, output capability, and flash rates for SignalMaster.
Outlines fuse capability and flash rates for relays.
Lists the components included in the SSP2000B kit with part numbers.
Guidance on choosing safe and suitable locations for system components.
Details connections, preparation, and initial system connection steps.
Covers connections for 10A, low-current relays, and general inputs.
Details wiring for SignalMaster, ambient sensor, and park input.
Wiring for speakers, horn ring transfer, and radio rebroadcast.
Covers control head, ignition power, microphone, and battery connections.
Adjusting the audio gain for the radio rebroadcast feature.
Adjusting the audio gain for the public address microphone.
Instructions for physically mounting the siren amplifier/relay module.
Instructions for physically mounting the control head.
Procedures for entering and exiting the control head programming mode.
Settings for notification beep, LED dimming, and keep-alive timeout.
Settings for active-high activation of horn-ring and park input circuits.
Procedure to reset the control head to its original factory configuration.
Procedures for testing the installed siren and light system.
Instructions for applying custom legends to control head buttons.
Guidance on distributing message cards and installing safety labels.
Important safety instructions for technicians servicing the siren system.
Procedures for removing, replacing slide switch, and reinstalling control head.
Instructions for uninstalling, replacing fuses/insulators, and reinstalling the module.
Information on obtaining technical support, ordering parts, and returning products.
To Next Page
