FedEx Ship Manager - Page 55

Chapter One: Setting Up FSMS
FedEx Ship Manager
®
Server User Guide, Version 7.6 53
The following Copy To All Meters section appears on the Label Settings tab for CA origin:
Laser and Thermal Air Waybill Defaults
To designate printers to print laser and/or thermal air waybills:
1. In the Laser and Thermal Air Waybill Defaults section of the Label Settings window, click the
printer icon next to the label type you want to configure or the folder icon to specify the directory to
which thermal label buffers should be saved.
NOTE:
To configure a laser and/or thermal printer in the Label Settings window, you must first
install the printer in your operating system.
2. The Printer Selection window is displayed with the printer you have set as a default in your
operating system. If you want to select this printer as either your laser printer or thermal printer, click
OK. To select another printer that has been installed on your operating system, click Properties in
the Printer Selection window to display the list of printers from which you may choose.
3. When you click OK, the printer you selected is displayed in either the Laser Printer ID or Thermal
Printer ID fields (depending on the printer type you chose to configure).
4. If you select a thermal printer in the Thermal Printer ID field, you must also select the Thermal Type
and Label Stock. To choose entries in these fields, select the pull-down list for each field and
highlight the appropriate choice.