ORIGINAL INSTRUCTIONS
the “off” position (Fig. 7B).
4. Standing behind the unit, grasp the brake control handle and hold it against the Lower handle. (Fig. 7C)
5. Keep hold the brake lever as shown Fig.7C and Grasp the starter handle as shown Fig 7D pull up rapidly.
Return it slowly to the rope guide bolt after engine starts.
6. Move the choke lever to the “on” position. (Fig.7F)
Note! When the cutter deck is in contact with the ground, the unit can move.
Fig.7A Fig.7B Fig.7C
choke lever
Fig.7D Fig.7E
6.2 TO STOP ENGINE
CAUTION: The blade continues to rotate for a few seconds after the engine is shut off.
1. Release the brake control handle to stop the engine and blade. (Fig. 8A)
2. Move the engine switch to “OFF” position. (Fig.8B)
To Next Page
Loading...