Fein ASCD18W2 - Page 15

15
en
Switching on and off (figure 6).
Check the power supply cable
and the plug for damage.
Always hold the power tool
firmly. Otherwise, you could
lose control over the power
tool.
In case of overload, the machine switches off.
Switching on:
Press the On/Off switch. The speed increases
the more you press the On/Off switch.
Switching off:
To switch off the power tool, release the
On/Off switch.
Switching on and off (figure 7).
Never look or stare into the
light of the power tool's lamp
from a short distance. Never point the light of
the lamp into the eyes of other persons in
close vicinity. The radiation produced by the
lamp can be harmful for the eye.
When pressing the On/Off switch completely
in, the light and the power tool are on.
When pressing the On/Off switch completely
in, the light and the power tool are on.
Handling the battery.
Operate and charge the battery only within
the battery operating-temperature range of
0°C – 45°C (32°F –
113°F). At the beginning of the charging pro-
cedure, the battery temperature must be
within the battery operating-temperature
range.
WARNING
CAUTION
Fig. 6
On/Off switch
WARNING
Fig. 7
Light
OBJ_BUCH-0000000122-001.book Page 15 Friday, April 19, 2013 10:39 AM