What to do if the rotor is not moving on my Fein ASCM 12 C?
If the rotor of your Fein Drill isn't moving, it could be due to several reasons. It might be a mechanical defect requiring replacement of the rotor or stator, a defective cable that needs replacing, a faulty toggle or standard switch needing replacement, loose battery plug contacts that need checking, or defective electronics that need replacing.
Why is the LED not lighting up on my Fein ASCM 12 C?
If the LED on your Fein Drill isn't lighting up, the issue might stem from a defective cable (check the cable), a faulty LED (check the LED), or defective electronics, in which case you should replace the electronics.
Why does the rotor only turn in one direction on my Fein ASCM 12 C Drill?
If the rotor of your Fein Drill only turns in one direction, the issue likely lies with a defective toggle switch or a defective switch, both of which would need to be replaced.
How to fix unusual noise from gearbox (rattling) in Fein Drill?
If you're experiencing unusual rattling noises from the gearbox of your Fein Drill, it's likely that the gearbox itself is defective and needs to be replaced.
What to do if torque shut-off cannot be adjusted on Fein ASCM 12 C?
If the torque shut-off on your Fein Drill cannot be adjusted, it is probably because the adjusting ring is defective, requiring you to replace the gearbox.
Why is the slide switch stiff on my Fein ASCM 12 C Drill?
If the slide switch on your Fein Drill is stiff, it could be due to a dirty slide switch (clean and lubricate it) or a defective slide switch (replace the gearbox).
What to do if drill chuck jaws stuck on Fein Drill?
If the drill chuck jaws are stuck on your Fein Drill, it's likely because the drill chuck was opened using the machine drive, and you will need to replace the drill chuck.
General| Voltage | 12 V |
|---|---|
| Max Torque | 30 Nm |
| Chuck Size | 10 mm |
| Battery Capacity | 2.5 Ah |
| Battery Type | Li-ion |
| Speed | 400 / 1300 rpm |
| Torque (soft/hard) | 30 Nm |
To Next Page
