Need help?Do you have a question about the Fein KBM 32 Q and is the answer not in the manual?
Test procedure for self-start lock, magnetic foot, motor operation, and overload cut-out.
Specifications and measured values for voltage, current, speed, and resistance.
List of necessary tools and equipment for testing procedures.
Electrical wiring diagram for the drill stand, motor switch, and drill motor.
Steps for safety checks including earth conductor, insulation resistance, and high voltage tests.
Steps to prepare the device for disassembly, including disconnecting power and switching off.
Procedure for removing the drill motor and associated components from the drill rig.
Instructions for removing the gear assembly from the drill motor.
Steps to disassemble the drill chuck, including removing the clamping lever and circlips.
Procedure for dismantling the gear components, including removing circlips and bearings.
Steps to dismantle the electric motor, including cover, carbon brushes, armature, and field magnet.
Procedure for disassembling the main drill rig assembly, including circuit board and magnetic foot.
Steps for assembling the electric motor, including armature, field magnet, and connecting components.
Procedure for assembling the drill chuck, including spring bearing, balls, and sleeve.
Steps for assembling the gear mechanism, including bearings, circlips, and gear wheels.
Procedure for assembling the main drill rig, including gear rod, bearing, and magnetic foot.
Instructions for inserting and fixing the pre-assembled gear into the motor guide.
Steps for assembling the motor with the drill rig gear, including fastening and adjusting feed speed.
Procedure for connecting the motor, circuit board, magnetic foot, and power lead.
To Next Page
General
