Fein KBM 32 Q - 2. Maintenance

Sahre/MVK 03/07
All rights reserved by FEIN, in particular as these apply to trademarks. FEIN
retains all powers of disposition such as copying and right of transfer.
FRT: KBM 32 Q
2. Maintenance
 Check power cable for damage
 Vent motor using dry compressed air
 Check carbon brushes
 General functional control
Carbon brush replacement:
The drill motor has carbon brushes with automatic switch-off.
The replacement should be done by an electrician, prior in
an authorised FEIN - workshop.
During the insertion of the new carbon brush observe free movement in the carbon brush holder.
New carbon brushes have to run in for 15 min in no load speed.
Only use original Fein - carbon brushes and Fein - replacement parts
 