To Next PageTo Next Page
Need help?Do you have a question about the Felder AD 941 and is the answer not in the manual?
Explains symbols for safety and operational instructions.
Guidance on safe and effective manual use.
Emphasizes genuine parts and safe disposal procedures.
Defines proper machine use and qualifications for operators.
Lists essential PPE and identifies key machine risks.
Covers additional hazards and prohibited operational practices.
Crucial safety guidelines for handling and inspecting the machine during transport.
Describes safe lifting, moving, and required operational space.
Emphasizes safety during setup and proper machine positioning.
Details dust extraction setup and electrical connection requirements.
Explains how to adjust chip thickness and machine joints.
Guides on adjusting the fence and converting between planer/thicknesser modes.
Procedure for calibrating the Digi-Drive control unit.
Troubleshooting common errors and their solutions.
Essential safety rules and procedures for operating the machine.
Approved and forbidden techniques for planing operations.
Routine maintenance tasks and critical safety guidelines.
Instructions for drive belt tension/replacement and fence angle correction.
Steps to take when a fault occurs and after rectification.
Troubleshooting guide for machine malfunctions.
Procedures for resharpening/replacing knives and servicing cutterblocks.
Visual guide to machine identification symbols and labels.
General