4
DELAYED START (ON 500C ONLY)
DELAYED START
Close drawer and
press clock icon on
control panel
Press once for
30 minute delay
(one LED will
illuminate)
Press twice for
60 minute delay
(two LEDs will
illuminate)
Press three times for
90 minute delay
(three LEDs will
illuminate)
Press four times to
reset clock
Allows you to delay shredding for 30, 60 or 90 minutes.
If a critical situation occurs while SmartLock™ is engaged and the shredder drawer
needs to be accessed, follow the steps below.
In case of a power outage, SmartLock™ will remain engaged.
Once power is restored, shred cycle will automatically resume.
**To cancel Delayed Start, press and hold Clock icon for 2 seconds
* Shredder will not run if the hatch is not in place. Always replace the
hatch to resume shredding.
Open drawer and
add paper
Locate the access
screw on the back of
the machine and turn
counter clockwise with
a 6mm allen wrench.
1 2
TROUBLESHOOTING
Overheat Indicator: When the Overheat Indicator is illuminated, the shredder has exceeded its maximum operating temperature and needs to cool down. This indicator
will remain illuminated and the shredder will not operate for the duration of the recovery time.
#JO'VMM8IFOJMMVNJOBUFEUIFTISFEEFSXBTUFCJOJTGVMMBOEOFFETUPCFFNQUJFE6TF'FMMPXFTXBTUFCBH
Drawer/Bin Door Open: The shredder will not run if the bin is open. When illuminated, close the bin to resume shredding.
Remove Paper: When illuminated, see Paper Jam section under Advanced Product Features.
1
The service hatch
will begin to rise.
,FFQUVSOJOHVOUJM
the hatch panel
is easily removed
from the top of the
machine.
3
To replace the service
hatch, position hatch
panel back on top of
the machine. Hold
panel in place while
turning the allen
wrench clockwise until
you feel resistance.
2
To Next Page
Loading...
Need help?
General
