Fellowes P400C-2 - User Manual

Questions and Answers

M
Mr. Matthew PenningtonJul 30, 2025
How to fix a Fellowes Paper Shredder that will not operate?
- T
  Thomas AliJul 30, 2025
  If your Fellowes Paper Shredder won't operate, several things could be the cause. First, make sure the shredder is plugged in and the power switch is in the AUTO (I) position. For P400C-2 models, ensure the shredder head is correctly situated on the basket, aligning the slot with the tab. Also, check for paper jams due to excessive paper and ensure the wastebasket is empty before moving the power switch to REVERSE (R). Finally, if the shredder has been running for too long, move the power switch to OFF (O) and let the motor cool down for at least 15 minutes.
Y
ycoleAug 4, 2025
What to do if Fellowes P400C-2 Paper Shredder only works in reverse?
- M
  Mark CamposAug 4, 2025
  If your Fellowes Paper Shredder only operates in REVERSE (R), a small piece of paper may be blocking the auto-start sensor. Move the power switch to the OFF (O) position and unplug the shredder. Turn the shredder head over and use a toothpick to clear any blockage at the auto-start location in the center.
T
Thomas WardAug 10, 2025
What to do if Fellowes Paper Shredder suddenly stops?
- M
  Madison GonzalesAug 10, 2025
  If your Fellowes Paper Shredder suddenly stops while shredding, it might have exceeded the maximum run time and needs to cool down. Move the power switch to OFF (O) and allow the shredder motor to cool for a minimum of 15 minutes. Alternatively, the shredder could be jammed due to excessive paper. Ensure the wastebasket is empty, then move the power switch to REVERSE (R) to clear any potential jam.
C
Chad GrayAug 17, 2025
Why does my Fellowes P400C-2 Paper Shredder run continuously?
- J
  jennifer95Aug 17, 2025
  If your Fellowes Paper Shredder runs continuously when in AUTO (I), a small piece of paper might be causing the auto-start feature to run non-stop. To resolve this, move the power switch to the OFF (O) position and unplug the shredder. Then, use a toothpick to carefully clear any paper blockage at the auto-start sensor, which is located in the center.
D
David BrownAug 22, 2025
How to lubricate Fellowes P400C-2 Paper Shredder?
- M
  Matthew AlvarezAug 22, 2025
  If your Fellowes Paper Shredder's performance has diminished or it's making squeaking or rubbing noises, the cutting blade likely needs to be oiled. To address this, move the power switch to the OFF (O) position. Then, apply the recommended lubricant across the full width of the cutters from the top of the shredder.