Fellowes POWERSHRED DS-1 - Key Components Overview; Power and Override Switches; Control Switch and Indicator Lights; Magnetic Safety Interlock

ENGLISH
Model DS-1
2
Active Not Active
Lift and
remove basket
Magnetic
safety interlock
KEY
H. Control switch and indicator lights
1. Auto-On (green)
2. Off
R 3. Reverse
4. Overheated (red)
5. SafeSense
®
Technology (yellow)
A. SafeSense
®
Technology
B. Paper entry
C. Mesh basket
D. SafeSense
®
override
switch
E. Step
F. Disconnect power switch
1. OFF
2. ON
G. See safety instructions
below
CAPABILITIES
Will shred: Paper, small paper clips, plastic credit cards, staples and junkmail
Will not shred: Continuous forms, adhesive labels, transparencies, newspaper, cardboard,
large paper clips, laminates or plastic other than noted above
Paper shred size:
Cross-Cut .................................................................................................... 4mm x 35mm
Maximum:
Sheets per pass (Cross-Cut) .......................................................................................... 11*
Cards per pass .................................................................................................................1
Paper width ........................................................................................................... 230mm
* A4 (70g), paper at 220-240V, 50 Hz, 2.0Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Maximum recommended daily usage rates: 100
sheets; 5 credit cards.
11 sheets per pass to avoid jams.
Fellowes SafeSense
®
shredders are designed to be operated in home and office
environments ranging between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius)
and 40 – 80% relative humidity
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
t 0QFSBUJPONBJOUFOBODFBOETFSWJDFSFRVJSFNFOUTBSFDPWFSFEJO
the instruction manual. Read the entire instruction manual before
operating shredders.
t ,FFQBXBZGSPNDIJMESFOBOEQFUT,FFQIBOETBXBZGSPNQBQFS
entry. Always set to off or unplug when not in use.
t ,FFQGPSFJHOPCKFDUToHMPWFTKFXFMSZDMPUIJOHIBJSFUDoBXBZ
from shredder openings. If object enters top opening, switch to
Reverse (R) to back out object.
t DO NOT use aerosol products, petroleum based or aerosol lubricants on
or near shredder. DO NOT USE “CANNED AIR” OR “AIR DUSTERS” ON
SHREDDER. Vapors from propellants and petroleum based lubricants may
combust causing serious injury.
t %POPUVTFJGEBNBHFEPSEFGFDUJWF%POPUEJTBTTFNCMFTISFEEFS
Do not place near or over heat source or water.
t 5IJTTISFEEFSIBTB%JTDPOOFDU1PXFS4XJUDI'UIBUNVTUCFJOUIF0/*
position to operate shredder. In case of an emergency move switch to OFF (O)
position. This action will stop shredder immediately.
t "WPJEUPVDIJOHFYQPTFEDVUUJOHCMBEFTVOEFSTISFEEFSIFBE
t 4ISFEEFSNVTUCFQMVHHFEJOUPBXBMMPVUMFUPSTPDLFUPGUIFWPMUBHFBOE
amperage designated on the label. The outlet or socket must be installed
OFBSUIFFRVJQNFOUBOEFBTJMZBDDFTTJCMF&OFSHZconverters, transformers, or
extension cords should not be used with this product.
t '*3&)";"3%o%P/05TISFEHSFFUJOHDBSETXJUITPVOEDIJQTPSCBUUFSJFT
t 'PSJOEPPSVTFPOMZ
t 6OQMVHTISFEEFSCFGPSFDMFBOJOHPSTFSWJDJOH
F.
A.
E.
C.
D.
B.
G.
H.