Need help?Do you have a question about the Fellowes Standard Morgana FRN-6 and is the answer not in the manual?
General| Brand | Fellowes |
|---|---|
| Model | Standard Morgana FRN-6 |
| Category | Industrial Equipment |
| Language | English |
Explains the purpose of the manual for dismantling and re-assembly.
Details ISO-Metric fasteners and their types used in the machines.
Defines terms used for general identification of machine areas.
Details securing side covers on the friction machine.
Details securing side covers on the suction machine.
Instructions for removing and dismantling the friction feed drive shaft.
Procedure for adjusting the drive hub position on the shaft.
Instructions for removing and re-assembling the feed clutch.
Step-by-step removal of the vacuum roller assembly.
Procedure to adjust vacuum roller parallelism with input rollers.
Instructions for disconnecting and connecting the vacuum hose.
How to tension the vacuum drive belt by adjusting bearing blocks.
Procedure for removing and replacing the twin grip drive belt.
How to tension twin grip and clutch drive belts.
How to tension the motor drive belt.
Steps to dismantle input rollers on the friction machine.
Steps to dismantle input rollers on the suction machine.
Instructions for removing the upper and lower output shafts.
Steps for removing ink transfer rollers and shaft.
How to adjust the transfer roller pressure.
Explains numbering registration and potential causes of error.
Lists operational issues that can cause registration problems.
Discusses machine-related issues affecting registration.
Mentions clutch issues causing registration errors.
Steps for removing the clutch assembly from the machine.
How to measure the over-travel of the clutch.
Procedure to adjust over-travel on old style clutch.
Procedure to adjust over-travel on new style clutch.
How to measure the actuator clearance.
Steps to adjust the actuator.
How to measure collar position for numbering.
Procedure to adjust collar position.
How to adjust the clutch position switch.
Steps for removing the main print shaft.
Procedure for re-assembling the main print shaft.
Steps for removing the platen from the machine.
Procedure for re-assembling the platen.
How to adjust the platen pressure and position.
Information on sensor maintenance and alignment for all machines.
Guidelines for replacing sensors as a matched pair.
How to adjust the position of main and exit guards.
How to adjust the stripper plate clearance.
Notes on compressor reliability and troubleshooting for suction machines.
Importance of filter replacement and warnings against cleaning.
Steps for removing the compressor unit.
Overview of the suction control valve and its environment.
Steps for dismantling the suction control valve.
How to gain access to the control system circuit board (PCB).
Diagnosing and fixing issues when the machine won't run.
Diagnosing and fixing issues when the machine won't feed.
Diagnosing and fixing issues when the machine won't number.
Description of the control box and its components.
How to access the control system enclosure and components.
Steps for removing the suction control PCB.
Details on the motor speed control board and cable connections.
Diagnosing and fixing issues when the suction machine won't run.
Diagnosing and fixing issues when the suction machine won't feed.
Diagnosing and fixing issues when the suction machine won't number.
To Next Page