Fender Paramount Series - Truss Rod Adjustment; Truss Rod Adjustment Guide

TRUSS ROD
FENDER PARAMOUNT TRUSS ROD ADJUSTMENT INSTRUCTIONS
To accommodate string geometry and eliminate buzzing from the
stringshittingthefretsduringvibration,everyguitarneckhas“relief”
—theamountofcurvaturerequiredforthestringstovibratefreely.
Neck relief can change as wood shrinks or swells, moving in response
to seasonal changes in relative humidity. To counteract this movement
yourParamountacousticguitarcontainsadual-actiontrussrod—the
trussrodnutislocatedattheheeloftheneck,insidetheguitar’sbody.
ADJUSTING THE TRUSS ROD | 1. Locate the truss rod nut 2. Using the supplied
4mmheadhexwrench,slowlyturnthenutaneighthtoaquarterofaturn
3.Turnthenutasindicatedintheillustrationsabove(Note:Inthe“neutral”
position the truss rod will feel loose, as there is no pressure against the neck.
Onceturnedpastthispositionyoushouldfeelthetrussrod“tightenup”
again.) 4.Afterturningthetrussrodlettheneck“settlein”tothenewposition
forabout10minutes5. Retune the instrument to standard pitch (if required)
and check the relief again; adjust the truss rod further if necessary
NOTE: It is possible to damage the truss rod by stripping the nut, or by over tightening the truss
rod, resulting in damage. If you don’t feel comfortable adjusting the truss rod yourself, please
take your instrument to your nearest Fender Authorized Service Center.
Too much relief | (turn truss rod
nut clockwise to counteract)
Too little relief | (turn truss rod nut
counter-clockwise to counteract)