OCTAVE BLENDER MODE
In this mode, the input signal is split into two fuzz
signals: the classic Fender Blender fuzz signal and a
sub-octave fuzz signal. The output level of both the
fuzz and sub-octave fuzz signals can be set individually,
allowing them to be blended to preference.
In Octave Blender mode, the clean signal is muted and
the VOLUME and BLEND controls in the FUZZ section
are disabled. The SUSTAIN, TONE and OCTAVE-UP
controls in the FUZZ section still function to shape the
tone of the fuzz signal. In the pedal’s two-knob OCTAVE
section at far left, the FUZZ LEVEL control knob now
controls the fuzz signal output level and the OCTAVE
control knob sets the sub-octave signal output level.
6
To set the pedal to Octave Blender Mode, turn on the eect (indicated by the Bypass Footswitch LED illuminating red) and
press the Octave Footswitch until the Octave Footswitch LED illuminates white. The Octave Footswitch LED will remain
illuminated white even when the eect is bypassed to indicate the mode of the pedal when you turn it back on. Pressing the
Octave Footswitch again will change the pedal to Original Blender Mode.