Need help?Do you have a question about the Fender Twin Amplifier and is the answer not in the manual?
General| voltage (120V version) | 120 volts AC |
|---|---|
| frequency (120V version) | 60 Hz |
| power (120V version) | 360 watts |
| voltage (230V version) | 230 volts AC |
| frequency (230V version) | 50 Hz |
| power (230V version) | 360 watts |
| 100V and 120V versions | 4A SLO-BLO, 125V min |
| 230V and 240V versions | T2A, 250V |
| input 1 | 1M ohm |
| input 2 | 136k ohm |
| nominal level | +2, -5.5, -13 dBV |
| output impedance | 4.2k ohm maximum |
| input impedance | 130k ohm minimum |
| nominal level | +1.3 dBV |
| recommended load | 22k ohm minimum |
| sensitivity | +1.3 dBV |
| input impedance | 130k ohm |
| nominal level | +3 dBV into 600 ohms or greater |
| switch selectable | 4, 8, or 16 ohms |
| output high setting | 100 watts RMS, 5% THD |
| output low setting | 25 watts RMS, 5% THD |
| speakers | Two Fender P/N 026488 Special Design 12” 8 ohm speakers wired in series |
Weight and Dimensions| height | 52.7 cm |
|---|---|
| width | 67 cm |
| depth | 29.2 cm |
| weight | 35 kg |
Description of input jacks and controls for Channel One, including Volume, Gain, and Tone.
Description of controls for Channel Two, including Volume, Gain, and Tone.
Explanation of the Mix, Reverb, and Presence controls for sound shaping.
Details on using pre-amp out and power amp in jacks for external connections.
Information on output bias adjustment and measurement points.
To Next Page