Number Decal Description
18
Rear wheels
Front wheels
Wheel nut information
Do not lubricate the wheel studs and fasteners.
Tighten the rear wheel fasteners to 750 Nm.
If it is applicable, tighten the front wheel fasteners to 900 Nm.
Do a check of the torque of the wheel fasteners:
1. Before you operate the machine for the first time.
2. After 1 hour of operation.
3. After 2 hours of operation (total).
After you tighten the wheel fasteners these 3 times, go to the
maintenance schedule to see the servicing interval for this task.
NOTE:
This decal shows on the front wheels of wheel only models too.
19
Tire pressure
The applicable tire pressure is on a decal adjacent to the tire valve
on the wheels.
20
Objects eject at high speed
Keep a safe distance from the cha spreader when it is in
operation.
21
12 V electrical system
The machine has a 12 V electrical system, that can operate at a
maximum of 120 W.
22
Diesel exhaust fluid (DEF) only
Do not add diesel or water to the DEF system. See the Operator's
Manual for more information.
23
Ultra-low sulfur fuel only.
See the Operator's Manual for more information.
24
Negative terminal
This is the location of a negative terminal for the electrical system.
4
1. Safety
IDEAL Series Combine 45
ACX2738370
To Next Page
Loading...
Need help?
General
