Number Decal Description
40
General safety alert
Operate the horn 2 times before you start the engine.
41
Electrical shock
You must operate the machine a safe distance from electrical
cables. Use caution when the cables are above the machine.
42
Emergency exit tool
Use the emergency exit tool to break the window and get out of
the operator cab in an emergency.
How to install the safety decals
1. Make sure that the installation surface is clean and dry.
2. Make sure that the temperature of the installation surface is not less than 5 °C (41 °F).
3. Find the correct position for the decal before you remove the cover paper.
4. Remove a small part of the cover paper.
5. Put the decal in the correct position on the installation surface. Carefully push the small part of the
shown adhesive surface of the decal on to the installation surface.
6. Slowly remove the cover paper and attach the decal to the installation surface.
7. Make small air holes in the decal with a pin and use the cover paper to make sure that the decal is flat.
Maintenance of safety decals
• Make sure that the decal is in the correct position on the machine.
• Keep the safety decals clean. Clean the safety decals with soap and water. Do not use strong or
abrasive materials or chemicals that can cause damage to the safety decals.
• Replace the safety decals that are missing or that are in a bad condition.
• Buy replacement safety decals from an approved dealer.
1. Safety
48 IDEAL Series Combine
ACX2738370
To Next Page
Loading...
Need help?
General
