8
EN
Lithium-Ion cells can be stored for a long
period without losing much of their
charge. When the machine is not being
used over a longer period of time it is
best to store the battery in charged
condition.
Fitting and removing drills or screwdriver bits
Fig. D
and screwdriver bits with a standard ¼ inch.
hexagonal shaft. To fit a screwdriver bit:
magnet.
it out of the bit holder again.
screws that are difficult to reach. Put it directly
into the machine’s bit holder.
Adjusting the direction of rotation
Fig. E
<<’ in
order to drive screws or to use it for drilling.
>>’ in
order to remove screws.
Switching the machine on and off
Fig. E
machine.
machine.
machine.
position to lock the movement of the on/off
switch. It cannot be activated in this position.
The machine is equipped with electronic
overload protection function. When the
machine gets overloaded it will shut
down automatically. When this happens,
please wait for at least 5 seconds to let
the overload protection reset itself.
Spindle lock function
Fig. F
The machine is fitted with an automatic spindle
the battery is empty) as a manual tool.
Work light (7)
Fig. A
The machine is equipped with a work light to
illuminate the work location.
switch is being pressed.
switch is released again.
User tips
When driving screws into wood, metal and other
materials:
screw bit is properly fitted and centered inside
the drill chuck.
dimensions. When unsure, always try if the bit
fits on the screw head without any free play
before using the machine.
it contacts the screw. A rotating bit may slip.
This could result in damage to the work piece.
straight line with the screw.
small amount of washing liquid or soap as a
lubricant to the screws thread.
tight screws or to firmly tighten screws.
to drill a hole with a depth equal to almost the
length of the screw. A pilot hole guides the
screw and prevents splintering or distortion of
the work piece.
To Next Page
Loading...
