Need help?Do you have a question about the Fermator VCI-VF5A.CD0 Series and is the answer not in the manual?
General| Brand | Fermator |
|---|---|
| Model | VCI-VF5A.CD0 Series |
| Category | Lifting Systems |
| Language | English |
Configures door control via one or two inputs.
Sets door type for automatic or semiautomatic landing.
Defines motor rotation direction for skate positioning.
Sets the unit as master controller or slave to lift controller.
Input signal used for ordering the door to close.
Isolated 12V output for door control via voltage-free contact.
Reference terminal for opening and closing signals.
Opposite pole to 12V, used for internal voltage inputs.
Signal that orders the door to open.
Port for diagnostic console and expansion devices.
Optional integration of Fermator photocell for safety.
Signal for cabin door switch or external barrier for re-opening.
Terminal for reopening order or slow closing via isolated contact.
Orders slow door closing, prioritized over other signals.
Input for emergency supplier to allow opening during power failure.
LED and relay for fully open door status.
LED and relay for fully closed and locked door status.
LED and relay for photocell or re-opening input activation.
LED and relay for detected obstacle during closing.
Blinking LED indicating proper working conditions.
Button to initiate a door open or close cycle.
Button to start the door learning/calibration cycle.
Detailed steps for the door autoadjustment procedure.
Potentiometer to set the door closing speed.
Potentiometer to set the door opening speed.
Potentiometer for closing pressure on obstacles.
Describes the encoder for position and speed feedback.
Output for the 3-phase motor, controlling speed and torque.
Disconnects the unit from the AC mains supply.
Configuration and input priorities for master mode.
Configuration and input priorities for slave mode.
Checks for motor cable, voltage, and motor issues.
Identifies encoder, connection, or supply problems.
Verifies DIP switch and motor phase connections.
Checks switch 2 for correct door sense and skate closure.
Verifies skate movement and potential mechanical friction.
Checks for obstructions and system integrity.
Connects inputs, priority inputs, photocell, and outputs.
Adjusts close speed, open speed, and safety force to minimum.
Tests door movement and adjusts parameters using buttons.
Checks grounding, connections, and signal stability.
Verifies VF control functionality or suggests replacement.
Indicates need for autoadjustment due to uncalibrated state.
Checks photocell, OPEN input, and close signal for issues.
Verifies safety potentiometer, photocell, and mechanical obstructions.
Checks mechanical adjustments and motor torque.
Checks skate regulation, locking, and friction.
Verifies skate unlocking fixation and adjustment.
Checks belt tension, encoder feedback, and autoadjustment.
Checks fuses and power supply to the VF control.
Verifies wiring, motor phases, and encoder pulley assembly.
Addresses obstruction, slave mode issues, or short circuits.
To Next Page
