Users’ Manual Millennia™ Backboard
8 © Ferno-Washington, Inc. 234-2019-01 July 1998
SECTION 5 - MAINTAINING THE BACKBOARD
5.1 Maintenance Schedule
The backboard requires regular maintenance. Set
up and follow a maintenance schedule.
The following chart represents minimum
maintenance.
When using maintenance products, follow the
manufacturers’ directions and read the
manufacturers’ material safety data sheets.
To order Ferno disinfectants and cleaners, con-
tact Ferno Customer Service, page 9.
5.2 Disinfecting the Backboard
Wipe all surfaces with disinfectant. Follow
disinfectant manufacturer’s directions.
Ferno recommends inspecting the backboard for
obvious damage as you disinfect it.
5.3 Cleaning the Backboard
1. Clean all surfaces of the backboard with
warm water and a mild detergent. Use a
stiff-bristled brush if necessary.
2. Rinse backboard with warm water.
3. Towel dry or allow to air dry.
5.4 Inspecting the Backboard
Have your service technician check the following:
q Is the backboard free of cracks and
crevices?
q If your service uses speed clips, are all ten
speed-clip pins solidly in place and free of
cracks or damage?
If inspection shows damage, remove the
backboard from service and destroy it to prevent
accidental use of a damaged backboard.
Disinfecting (this page)
Cleaning (this page)
Inspecting (this page)
•
Each Month
As Needed
Each Use
•
•
•
Improper maintenance can cause injury.
Maintain the backboard only as described
in this manual.
WARNING
!
Important
Do not attempt to repair the backboard.
Repairs can cause backboard performance
to be unpredictable. Repairs will void the
warranty.
To Next Page
Loading...