Fernox TF1 User Manual

TF1 installation and cleaning
Quick Reference Guide
Lid tightening
www.fernox.com
Full instructions enclosed in the TF1 box.
In the event that the lid of the
TF1 filter has been removed,
ensure the lid is fully re-tightened
to the correct position.
Either line-up the yellow arrow
inside the yellow box on the
side of the TF1 (Diagram A)
or align the embossed marks
on the lid (Diagram B), using
the TF1 spanner provided.
Fast clean for TF1 Total Filter & TF1 Compact
– no need to remove lid
30 seconds
Close inlet and
outlet valves
Open outlet and
drain valves
Close drain valve,
replace magnet and
open inlet valve
Remove magnet
1 2 3 4
The TF1 unit does not need to be disassembled for installation, cleaning or servicing however if disassembled, replace all
appropriate seals for example the lid collar/bleed valve ‘O’ rings, as good practice dictates (spares are provided with product
in box). Additional Fernox TF1 Range Seal and ‘O’ ring kits are available: item number 59288.
A B

Fernox TF1 Specifications

General

Application	Central Heating Systems
Seal Material	EPDM
Connection Size	22mm
Installation Orientation	Horizontal or Vertical
Filter Media	Magnetic
Valve Material	Brass

Summary

TF1 Installation and Servicing

Lid Tightening Procedure

Ensure the TF1 filter lid is fully re-tightened correctly using alignment marks.

Fast Cleaning (No Lid Removal)

A quick cleaning method for TF1 Total Filter and Compact without removing the lid.

TF1 Orientation Adjustment

Unlock and Rotate Port

Unlock the clip, pull the port away, and rotate to the desired position.

Lock Port in Position

Push the port back and secure the locking clip to lock the orientation.

TF1 System Installation

Sealed System Placement

Illustrates best and good positions for TF1 in a sealed heating system.

Open Vented System Placement

Illustrates best and good positions for TF1 in an open vented heating system.