AUTOMATIC FISH FEEDER
Thank you for choosing CHEF PRO, the new automatic
feeder for fish tanks.
Page 3:
1 Container body 2 Auger
3 Motor body 4 Electronic control card
5 Slide 6 Pin
7 Front door 8 Hatches for the food outlet
!
WARNINGS
• This appliance can be used by
children aged from 8 years and
above and persons with reduced
physical, sensory or mental capa
-
bilities or lack of experience and
knowledge if they have been
given supervision or instruction
concerning use of the appliance
in a safe way and understand
the hazards involved. Children
shall not play with the appliance.
Cleaning and user maintenance
shall not be made by children
without supervision.
• Make sure the batteries are
placed in the correct order (see
picture inside their compart
-
ment). Placing the batteries in
the inverted order may damage
the product.
• Disposal of batteries must be
done according to applicable
regulations.
• Make sure you use two 1.5 Volt
AA LR6 alkaline batteries (not
rechargeable alkanine batter
-
ies - not included). Do not use
rechargeable batteries.
• If the batteries leak, please take
them away immediately.
• In order to maintain the feeder
settings when changing batter
-
ies, make sure that you replace
the batteries within 5 minutes.
• Although batteries can power the
feeder for a long period of time,
we recommend replacing them
before long periods of absence.
• Always replace the batteries
when the relative red LED flashes
slowly.
• Place the feeder at a distance of
2.5 cm at least from the front
panel (fig. A), in order to ensure a
perfect opening of the front door.
• Do not place the feeder in areas
subject to splashes of water or
high levels of relative humidity.
• Do not pack too much food into
the feeder (especially in the case
of fine granular food).
• This feeder is not designed for
underwater use.
• The CHEF PRO feeder can be
integrated into CAYMAN or STAR
aquariums. (in the CAYMAN
aquarium, once the feeder is in
position, we recommend leav
-
ing the compartment door open
for greater efficiency and better
ventilation).
PROGRAMMING (FIG. B)
P1 / P2 / P3
Programming daily feeding sessions (up to 3 feeding ses-
sions per day).
I.e.: it’s 8 a.m. and you press the P1 button, the feeder will
supply one food session daily at 8 a.m. The same with the
P2 and P3 buttons. If both LEDS are on at the same time, the
feeder has not yet been programmed.
+2 h
Regulation of the period of time between the programming
time and the time of the first, second or third feeding
4
CHEF PRO
EN
PL
RU
DA
SV
HU
CS
SK
ES
NL
D
FR
IT
PT
To Next Page
Loading...
