11
Loss of control and roll-over hazard.
Operating on slopes can be hazardous and
cause loss of control and roll-overs.
• Do not operate on slopes over 10
degrees.
• Avoid sudden turns or rapid speed
changes.
• Reduce speed and use extreme caution
on slopes.
• Avoid turning down slopes; if possible
turn up slopes.
• If machine stops forward motion on a
slope, stop the blades and drive slowly
off the slope.
Water, retaining walls, and drop-off
hazards.
Wheels dropping over edges may result in
serious injury, death or drowning.
• Do not operate down slope towards or
near water, retaining walls, or drop-offs.
• Give yourself a minimum of two mower
widths of clearance around these
hazards.
WARNING
Fire hazard.
Gasoline is flammable. Yard debris is
combustible.
• Allow engine to cool for at least 3
minutes before refueling.
• Keep unit cleaned of debris.
• This equipment may create sparks that
can start fires around dry vegetation. A
spark arrester may be required. Contact
local fire agencies for regulations
relating to fire prevention requirements.
Avoid serious injury or death.
Read the operator's manual before using
this product.
• Do not operate this machine unless you
are trained.
• Know the location and function of all
controls.
• Keep safety devices (guards, shields,
switches, etc.) in place and working.
• Remove objects that could be thrown
by the blade.
• Be sure blade(s) and engine are
stopped before placing hands or feet
near blade(s).
• When leaving machine, shut off,
remove key, and set parking brake.
7101665 - Decal, Danger, Discharge
Safety alert triangle.
DANGER
Keep hands and feet away from deck.
Do not operate mower unless discharge
chute or entire grass catcher is in its proper
place.
Safety Icons for Optional Jack Kit
Accessory
An optional jack kit is available as an accessory through your
normal parts source. Please see the explanations below for
the safety icons displayed on the jack kit.
Part Number:5105632 - Decal, Warnings, Svc Jack
1.) Warning - Read the Operator's Manual.
2.) Crushing Hazard, Mower:(1.) Park machine on flat
level ground and engage the parking brake; (2.) Stop the
engine and remove the ignition key; (3.) Properly jack the
machine and secure with jack stands before working under
the machine.
To Next Page
Loading...
Need help?
General
