EasyManuals Logo

Ferris ISX2200 Series User Manual

Ferris ISX2200 Series
56 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Not for
Reproduction
15
Warning: Consult technical literature
before performing technical repairs
or maintenance. When leaving the
machine, shutoff engine, set the
parking brake to the lock position,
and remove the ignition key.
Danger - Amputation and
dismemberment hazard: To avoid
injury from rotating blades and
moving parts, keep safety devices
(guards, shields and switches) in
place and working.
Danger - Loss of traction, sliding,
steering and control on slopes
hazard: If machine stops forward
motion, stop the blades, and drive
slowly off the slope.
Danger - Amputation hazard: Do
not mow when children or others are
around. Never carry riders especially
children even with the blades off. Do
not mow in reverse unless absolutely
necessary. Look down and behind –
before and while backing.
Danger - Tipping and slipping
hazard: Operating on slopes can
be hazardous and cause a loss
of control and roll-overs. Do not
operate on slopes over 15* degrees.
Avoid sudden turns or rapid speed
changes. Reduce speed and use
extreme caution on slopes. Avoid
turning down slopes; if possible,
turn up slopes. Do not operate
down slopes towards or near water,
retaining walls, or drop-offs. Give
yourself a minimum of two mower
widths of clearance around these
hazards.
Danger - Thrown objects hazard:
Keep bystanders and children a
safe distance away. Remove objects
that can be thrown by the blade. Do
not mow without discharge chute in
place.
*This limit was determined per International Standard ISO 5395-3:2013,
Section 4.6 and is based on the ISO 5395-3 Stability Test procedure
described in Annex A. The 15 degree “limit of stability” is equal to 60%
of the angle at which machine lift-off occurred in static tests. Actual
dynamic stability may vary depending on operating conditions.
5061246 - Decal, Pinch Point
Danger: Dismemberment - This machine
can crush and cut. Keep hands away from
deck lift rod.
5102456 - Decal, Fire
Danger: Fire Hazard: Keep unit free of
grass, leaves and excess oil. Do not add fuel
while engine is hot or running. Stop engine,
remove key and allow to cool for at least 3
minutes prior to adding fuel. Do not add fuel
indoors, in an enclosed trailer, garage or
other enclosed areas. Clean up spilled fuel.
Do not smoke while operating this machine.
Battery Safety Decal
Warning: Fire Hazard - Keep children,
open flames and sparks away from the
battery, which could ignite explosive gases.
Warning: Sulfuric acid can cause
blindness or severe burns -Always
wear safety goggles or a face shield when
working on or near a battery.
Warning: Batteries produce explosive
gases - Read and understand the
Operator’s Manual before using this
machine.
Important: Do not discard a battery in the
trash - Contact local authorities for disposal
and/or recycling of batteries.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Ferris ISX2200 Series and is the answer not in the manual?

Ferris ISX2200 Series Specifications

General IconGeneral
Deck ConstructionFabricated
Spindle MaterialCast Iron
Engine BrandKawasaki
Cutting Width61 inches
Cutting Height1.5 - 5 inches
TransmissionHydro-Gear ZT-3400
Deck Material10-gauge
Ground Speed (Forward)10 mph
Ground Speed (Reverse)5 mph

Related product manuals