HE Programmer instructions
Programmer overview A B C
Clock adjustment button
B:
Operating mode button
C:
Override button
D:
- Button
E:
Programming button
F:
+ Button
D E F
Setting the time and day
1. Press the
button.
2. The Day and clock symbol will flash on the display using the + and – buttons set the Day (1= Monday
7= Sunday)
3. Press the button.
4. The hour and clock symbol will flash using + and – buttons set the correct hour (this is a 24 hour clock)
5. Press the button.
6. The minutes and the clock symbol will flash using the + and – buttons set the correct minutes.
7. Press the button the time and day are now set.
Pre Set programmes
1. Central heating.
The timer is Pre programmed with 3 on and 3 off times. Set the same for each day.
These are: The 2
nd
on/off time will not allow the boiler to fire.
2. Domestic hot water ECO/Comfort
The timer is fitted with a function that will time the boilers hot water pre heat.
The pre heat will keep the hot water inside the boiler at its set temperature.
The timer is pre programmed with 1 on and off time. Set the same for each day.
This time is 6:30-22:30.
If these are suitable no programming is required and the C/H and the hot water comfort will be on for these
times. (The C/H 12:00-12:00 programme will not fire the boiler.)
Operating mode
By pressing the M button you can select: heating continuous, heating timed and heating off. When in these
modes the display will show.
Heating continuous Heating timed Heating off
http://waterheatertimer.org/Woods-timers-and-manuals-old.html#Remeha
To Next Page
Need help?
General
