Need help?Do you have a question about the Ferroli Lamborghini EXTREMA 30 C and is the answer not in the manual?
General| Boiler type | Condensing |
|---|---|
| Power Output | 30kW |
| Mounting | Wall-mounted |
| Max Working Pressure | 3 bar |
| Fuel Type | Gas |
| Electrical Supply | 230V |
Introduces the EXTREMA boiler, its features, and the manual's purpose.
Details the boiler's control panel and its functions with a key.
Explains how the boiler indicates heating, DHW, and comfort modes on the display.
Provides instructions for powering the boiler on and off, including frost protection.
Covers summer/winter switchover, heating, and DHW temperature settings.
Explains the ECO and COMFORT modes for domestic hot water delivery.
Details how the optional external sensor adjusts heating temperature based on outside conditions.
Describes how to adjust compensation curves using the heating buttons and DHW buttons.
Explains the required system pressure and fault codes related to pressure.
Outlines general installation requirements, safety regulations, and applicable standards.
Details requirements for the boiler's installation location, including ventilation and clearances.
Provides important information and requirements for connecting the boiler to the plumbing system.
Explains the installation of shutoff valves for isolating the boiler from the system.
Discusses the need for replenishing sealed systems and connections to water mains.
Describes the procedure for filling the system using the provided filling connector.
Recommends water treatment products and contacts for information.
Details requirements for connecting the boiler to the gas supply.
Outlines requirements for electrical connection, earthing, and wiring.
Provides caution regarding connecting room thermostats and their wiring.
Explains the requirements for the "C type" sealed chamber boiler's flue system.
Details standard and other coaxial pipe connections for the flue system.
Shows starting accessories for coaxial ducts and provides length limitations.
Illustrates examples of connecting with separate pipes and starting accessories.
Presents starting accessories for separate ducts and lists losses for components.
Provides minimum dimensions for fume exhaust terminals at various positions.
Describes requirements for connecting to multiple or single flues with natural draught.
Details the installation of the internal condensate drain trap and its connection.
Explains how to convey condensate, pipe material, and preventing freezing.
Covers gas conversion procedures and modifying gas type parameters.
Lists checks to be performed before and during boiler operation.
Provides general notes and test mode procedures for commissioning the boiler.
Explains how to put the boiler into test mode and check heating power.
Details how to check gas inlet pressure at maximum rate.
Provides a table for measuring gas rates for different boiler models.
Lists checks for routine servicing and maintenance of the combustion circuit.
Advises on the necessary competence and assessment for combustion performance checks.
Outlines annual checks for control devices, circuits, and components.
Details the steps for opening the boiler casing for internal access.
Explains how to connect a flue gas analyzer and check combustion.
Guides on adjusting the throttle and offset settings for the air/gas ratio valve.
Describes how to re-check the minimum rate output after adjustments.
Explains the boiler's self-diagnosis system and fault codes.
Provides a detailed list of boiler faults, their possible causes, and cures.
Shows diagrams of the boiler's dimensions and connection points.
Provides a general view of the boiler with numbered main components and a key.
Illustrates the internal water circuit of the boiler with a diagram and key.
Presents a comprehensive table of technical data for EXTREMA 30 C and 38 C models.
Displays pressure loss diagrams for circulating pumps for both boiler models.
Shows the electrical wiring diagram for the boiler and its components.
To Next Page