'$$,$
# ((..) %).%%$G% #
# % ) (($).%%
%)8%$" )4$%5
.#
# ;8."9/ 4(4 4#1%$4$5
%" %$ %'$$($)"%#
# (. .."9(%( .
(#
D# )$$$G%
"9"(#
# ($((%. .(
( . )$8#
)& ,%
%8)$ %).$8)%
% 8%).$#%!$$ %$$%8.
%.$(#=,()> ).
%(($ %#
D A N G E R ! $$
'0
)) ,%
N O T I C E ! The shut down procedure may only be initiated by skilled
personnel according to the definition in DIN EN 60 204.
D A N G E R ! The following procedure for switching off is to be followed
without fail before carrying out any cleaning, repair or maintenance work
#
Switch off the unit:
#
Switch off the high voltage unit with the HV-off button at
GENIUS
hand remote.
#
Turn off the On/Off switch located in the back of the
GENIUS
(X101).
#
Turn off the On/Off mains device switch at the front of the high voltage power supply.
D#
Switch off the main circuit breaker at the back of the high voltage power supply
#
Pull out the mains plugs at the controll device
GENIUS
X101, the filament power supply
FPS X201 and the high voltage power supply HVP X301.
#
Wait for at least 3 minutes before starting work on the electrical equipment. The capa-
citors must discharge themselves
=(% $.8#%
8%$#?%)%$
$%$")#
+##
0!0 =,()>
To Next Page
Loading...